Optimization of Friction Stir Welding Parameters for High-Strength Aluminum– Magnesium Alloy Joints
DOI:
https://doi.org/10.64751/4pvx1m16Abstract
The increasing demand for lightweight, high-strength, and corrosion-resistant structural materials has significantly expanded the application of aluminum–magnesium (Al–Mg) alloys in aerospace, automotive, marine, railway, and defense industries. These alloys offer an excellent combination of low density, superior specific strength, high corrosion resistance, and good formability, making them suitable for advanced engineering structures where weight reduction and mechanical performance are critical. However, conventional fusion welding techniques such as Gas Metal Arc Welding (GMAW), Tungsten Inert Gas (TIG) welding, and Laser Beam Welding often produce defects including porosity, solidification cracking, distortion, residual stresses, and undesirable microstructural transformations due to localized melting and rapid solidification. These limitations adversely affect the mechanical integrity and long-term reliability of welded Al–Mg alloy structures. Consequently, Friction Stir Welding (FSW), a solid-state joining technique, has emerged as an effective alternative for producing high-quality aluminum alloy joints with superior mechanical properties. Friction Stir Welding utilizes a non-consumable rotating tool consisting of a shoulder and profiled pin to generate frictional heat below the melting temperature of the base materials. The softened material undergoes severe plastic deformation and dynamic recrystallization, resulting in refined grain structures and defect-free joints without melting. The quality of friction stir welded joints is strongly influenced by process parameters such as tool rotational speed, traverse speed, axial force, tool tilt angle, plunge depth, and pin geometry. Improper parameter selection may lead to insufficient material flow, tunnel defects, void formation, excessive flash generation, or poor mechanical performance. Therefore, systematic optimization of welding parameters is essential for achieving maximum joint strength, improved microstructural characteristics, and enhanced process efficiency. This research presents an Optimization of Friction Stir Welding Parameters for High-Strength Aluminum–Magnesium Alloy Joints through comprehensive numerical and experimental evaluation of critical welding parameters. Various combinations of rotational speed, welding speed, axial force, and tool tilt angle are investigated to determine their influence on material flow behavior, heat generation, tensile strength, hardness distribution, elongation, residual stress, and weld quality. Statistical optimization techniques are employed to identify the optimum parameter combination capable of maximizing joint performance while minimizing welding defects. The developed methodology enables detailed analysis of the thermo-mechanical behavior occurring during the friction stir welding process. The obtained results demonstrate that optimized friction stir welding parameters significantly improve joint quality by promoting uniform material mixing, fine-grained microstructure, and defect-free weld formation. The optimized process produces higher ultimate tensile strength, improved hardness, greater ductility, lower residual stresses, and enhanced welding efficiency compared with non-optimized parameter combinations. The developed optimization strategy provides an effective manufacturing approach for producing high-strength aluminum–magnesium alloy joints suitable for lightweight structural applications. The proposed methodology offers significant benefits for aerospace structures, automotive body components, marine vessels, railway coaches, pressure vessels, defense equipment, and advanced industrial fabrication requiring reliable and high-performance welded joints.
Downloads
Published
Issue
Section
License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.







